(EURO-standard)Guarantees easy coupling and uncoupling of all working units (nearly all new frontloader-units require this kind of attachment)• suitable for all frontloaders• one-handed operation• two hanging points on each side for the pushing and lifting bar– this allows individual adjustment of the tipping angles • coupling without dismounting
The total width is 1140mm. The inner width (the distance between the two innermost uprights) is 825mm. The width between the inner and outer plate on each side is 160mm.
The pins supplied for mounting onto your loader are 30mm diameter
The diameter of the top bar where the implement attached is 29mm and the bottom which it rests against is 42mm. The distance between these two bars is 274mm, from the top of the bottom and bottom of the top bar.
If your loader is the same width to fit between the two uprights it should not be too much of a job.
There is also a hydraulic version of the above available at extra cost, or a simple weld on unit so as to make your own brackets for or to weld onto your existing face plate.
The total width is 1140mm. The inner width (the distance between the two innermost uprights) is 825mm. The width between the inner and outer plate on each side is 160mm.
The pins supplied for mounting onto your loader are 30mm diameter
The diameter of the top bar where the implement attached is 29mm and the bottom which it rests against is 42mm. The distance between these two bars is 274mm, from the top of the bottom and bottom of the top bar.
If your loader is the same width to fit between the two uprights it should not be too much of a job.
There is also a hydraulic version of the above available at extra cost, or a simple weld on unit so as to make your own brackets for or to weld onto your existing face plate.