Pulley to fit on male 6 spline pto shaft

Rimjob

Member

Location

near home

• May 3, 2017

• #1

As the title suggests I'm after a v belt pulley that will ideally fit direct onto a 6 spline male pto shaft.
I've a drain jetter that I rarely use below 1000rpm. Meaning unimog revving its cock off supping diesel when there's no need. I have an input shaft with pillow block bearings and a large pulley available just need a v pulley approx 5" diameter that will slot straight onto jetter pto input shaft so mog makes 1000rpm at tickover....
Is such a thing available off the shelf or is it a manufacturing job?
Cheers rob

 

D

Drillman

Member

Mixed Farmer

• May 3, 2017

• #2

You can get pulleys that fix onto p harrow output shafts on the back of the gearbox to run the fans on accord drills. That might do the job.

Maybe a bit big though

 

Dog&stick

Member

Mixed Farmer

Location

Herefordshire

• May 3, 2017

• #3

The drive on a accord drill, is take off the power Harrow output pto, 6 spline ,pulley maybe 10" dia twin v!

 

Dog&stick

Member

Mixed Farmer

Location

Herefordshire

• May 3, 2017

• #4

You beat me to it lol

 

The Stig

Member

Location

East Cambs

• May 4, 2017

• #5

You can get taper lock to fit six spline shaft

 

joe soapy

Member

Location

devon

• May 4, 2017

• #6

The Stig said:

You can get taper lock to fit six spline shaft

Click to expand...

That is the best solution, a good solid fix saves wear on shaft and pulley after extended use

 

A

acorn

Member

Livestock Farmer

Location

Lancashire, Home of the Deluge

• May 4, 2017

• #7

I found a gearbox on Ebay. It is geared 1 to 4.

Was off an old direct cut forager I believe.