Today at work
- Thread starter Penmoel
- Start date
- Location
- Near Colchester
Grab or 3 in one bucket on the telescopic, bonfire, scrapyard.Any suggestions on removing fencing, approx 7km to take out, sheep netting, barb and high tensile, posts rotten at ground level
We have a 4 in 1 for loader, big heap, big fire, then a big magnet out there f an old amplifier to pick up staples!Any suggestions on removing fencing, approx 7km to take out, sheep netting, barb and high tensile, posts rotten at ground level
Either that or pull staples out and roll up. Either way is crap
Courier
Member
- Location
- M62 - M1 - M18 triangle
yep, vans on it limit of 3.5T
3.5T is meant to be the Gross Weight - not the load.
Van is at 3.5t gross inc load, just ignore the trailer
think it stopped quicker with the loaded trailer on than it does normally 
- Location
- Bedfordshire
davidroberts30
Member
- Location
- pembrokeshire
Do i win for being the closest
Mickeymatbro
Member
Mickeymatbro
Member
Nearly
Member
- Location
- North of York
Is that @roscoe erf in the middle?
- Location
- N.Lincs
There were no fields of maize within a mile or 2 this year so they must have been Brock's take away
It's amazing where maize cobs end up. They seem to appear randomly when there is no maize close by. I always thought it was foxes
I've always thought it was foxes but yesterday I saw a crow fly past with one sticking out it's mouth like a big cigar
Shovelhands
Member
- Location
- Sunny Essex
Calm and peaceful start on the marshes this morning
went and took the scaffolding down on this yesterday. Really pleased with how it's turned out...
A vast improvement on the rotten rubbish that we started with
Chris Cook
Member
- Location
- Lower Quinton, Warwickshire
Hi davedb, it copes OK, you can track and flail, it does sap some of the power but it does keep turning. It is a nice piece of kit though
I wish
- Location
- Near Colchester
The whole lot of the plumbing will be below a DPM, the joints all have a big shovelful or two of soft sand round them so that there is only a 2 inch thick bit of concrete above - where the joints are is under the metal-work of the drinker-holder so no direct hoof/or telescopic loader will drive near them either.
I have dug too many joints up over the years to want to concrete in a tee.
- Location
- Near Colchester
I guessed that you were about to unlevel some more of Essex and there you go again.Calm and peaceful start on the marshes this morning
- Location
- Near Colchester
I use one of these workshop floor magnets for that staple bit, they are very efficient as you just pull a handle and all scrap is released.
https://www.sitebox.ltd.uk/clarke-m...MIppSv_anA1wIVFijTCh0FsgmkEAQYASABEgKN6PD_BwE
Shovelhands
Member
- Location
- Sunny Essex
I guessed that you were about to unlevel some more of Essex and there you go again.
Have no fear, it's not that level here anyway, the area is flat, but very few bits are actually 'level', I'm not destroying the precious landscape
davidroberts30
Member
- Location
- pembrokeshire
hope you didnt leave will alone there