Now flashing "error 3" on the displayI've got "error 5" on my display any able to shed some light on the problem?
Now flashing "error 3" on the display
The power supply should be ok, it's been working fine up to now at leastError 3 , the sensor for counting the amount of turns isn't getting a signal, either it's not picking up the Magnet, the table is going to slow, the sensors broken or there's a broken wire to the sensor.
Can't remember what error 5 is with out looking at the book which I haven't got handy just now,
Have you got a good power supply to the box ?
The power supply should be ok, it's been working fine up to now at least
Yes got it going, turned out to be a burst solder on the circuit board, wee did of solder and jobs done, thanksThey do like a good power supply
Did you get it going again ?
Quick question about these wrappers,
Should it be possible to start the auto sequence from the main control box, without the remote ?
I've been trying today but no joy !
Cheers
Yes it should do. The bottom switch click it to the right where it says OK, that should start the cycle.
So what does the 'auto' button on the left do then ??
Ah, GotchaIf you want to change the amount of turn the table does to a cycle, you press select then use the plus/minus buttons to get to the number of turns you want then press auto and it then does the whole cycle automatically when you press OK on the remote control.
You should have a double arrow button near the auto and select button. Press this and she will return to the start of the program and also not count the aborted run as a bale.Ok, I'm back again!!
How do I get it to reset the wrap count to zero when it breaks the wrap and I stop it spinning to re attach.. without tipping the bale off and starting again ..
Ideal,You should have a double arrow button near the auto and select button. Press this and she will return to the start of the program and also not count the aborted run as a bale.
Ideal,
Cheers, I've finally gotten the hang of her !!