Exfarmer
Member
- Location
- Bury St Edmunds
Looking good so far, never had too much trouble getting them back together in the past, good luck
David Brown 990 clutch
- Thread starter Phil P
- Start date
tomlad
Member
- Location
- nr. preston
Rope seal ?
- Location
- North West
Yes, come as a kit with the gaskets. Just a bit fiddly trying to line everything up behind the crank flange.
- Location
- North West Wales
Not telling any one how to suck eggs and all that but I always soak the rope seals in oil overnight.
- Location
- North West
I did oil them before installing, and it’s now sitting over night. Will that qualify?
- Location
- North West Wales
I did oil them before installing, and it’s now sitting over night. Will that qualify?
It will have to wont it!!! To be honest I’ve yet to come across an oil tight rope seal!!! Out of interest when was the last time you did a conventional clutch? Sure I’ve not done one personally for three years or more in a tractor! Did throw one in the car when the DMF started to complain last year!
- Location
- North West
March was the last one, can’t honestly remember before that but I usually get one a year. Everything else is wet clutches now with probably averages out at one a month over the year.
- Location
- North West
Not many pictures today as there wasn’t really a lot left to do.
Pushed the two half’s back together, went pretty easy just had to turn the shafts a little to line up the splines.
New starter as the old one had recently started not wanting to kick in, and a tractor that won’t start is no use to anyone!
And she lives to run the dryer for another year
Pushed the two half’s back together, went pretty easy just had to turn the shafts a little to line up the splines.
New starter as the old one had recently started not wanting to kick in, and a tractor that won’t start is no use to anyone!
And she lives to run the dryer for another year
Exfarmer
Member
- Location
- Bury St Edmunds
Cracking job
- Location
- North West
Thank you.Cracking job
- Location
- North West Wales
How was she to calibrate afterwards, fill times ok? PWM valves working as they should? Do you need to re gas the A/C now or did the couplings seal ok!!
- Location
- North West
Took a bit to set the free play on the pedal as the laptop wouldn’t continueHow was she to calibrate afterwards, fill times ok? PWM valves working as they should? Do you need to re gas the A/C now or did the couplings seal ok!!