its.... only me
Member
- Location
- sh!t creek
Has anybody either done something like this, or heard or know of anyone that has successfully converted a trailed FreeFlow to use as a mounted drill.
I was thinking a 4 m. version might make a cheap folding tine seeder
Thoughts were drop the front draw bar off and fit a three point linkage - with support stays back to the rear of the drill frame, also remove the rear packer ( to elevate weight) & move the following harrow and pre-em. markers closer to the drill frame. Seeding depth would be set on front packer roller & tractor hydraulic top link.
I appreciate this would weigh “a bit” but it would be on a 200hp plus tractor.
Just something I’am “mulling over”. Am I nuts and wasting my time - or am I on to something ??
Thoughts and comments appreciated.
TIA
IOM
I was thinking a 4 m. version might make a cheap folding tine seeder
Thoughts were drop the front draw bar off and fit a three point linkage - with support stays back to the rear of the drill frame, also remove the rear packer ( to elevate weight) & move the following harrow and pre-em. markers closer to the drill frame. Seeding depth would be set on front packer roller & tractor hydraulic top link.
I appreciate this would weigh “a bit” but it would be on a 200hp plus tractor.
Just something I’am “mulling over”. Am I nuts and wasting my time - or am I on to something ??
Thoughts and comments appreciated.
TIA
IOM