https://byeengineering.co.uk/agriculture/
Not much on the website.
The backend is a dubble drive axle set from a lorry, in front of the axle is a short prop shaft jointed to a truck gearbox. The input is from the tractors pto shaft. The dolly gearbox gears are selected from the cab via a...
I get a local engineering company to punch out my cutter for my Bunnings. The cutter are 300mm, 55mm, 20mm and 16mm holes. All done on an Iron Worker.
The bottom paddle work about £20 each.
Think cost about £5 each.
A big part of the story is about how the GP was attacked by the farmer and his tractor.
A few lines about how the GP had driving into the farm yard and drove his car into the tractor.
Not a very even story.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.