Recent content by 4755dave

  1. 4755dave

    Avadexer build.....my way

    Arden cabs from Willenhall. Long gone..... What do you need for what. I have found some bits aftermarket
  2. 4755dave

    Avadexer build.....my way

    Couldn't resist plonking it on..... Luckily it fits
  3. 4755dave

    Avadexer build.....my way

    She's pretty good to be fair. 30 plus years old orings znd seals gone hard
  4. 4755dave

    Avadexer build.....my way

    Nope Failed on excessive oil leaks. Clutch housing is out of it at mo
  5. 4755dave

    Avadexer build.....my way

    Spreader nozzles from Techneat going on. Made to my design and diameter.
  6. 4755dave

    Avadexer build.....my way

    Well.... That's just about the image I had in my head
  7. 4755dave

    Avadexer build.....my way

    No I plan on drive the 4 units with ujs znd shafts . Accord do unit shut off clutchs on 6m drills
  8. 4755dave

    Avadexer build.....my way

    Thanks. I have a kuhn aero rate controller and hyd motor with valve which will drive and vary rate once set Yes individual metering unit shut off to give 4 section controls
  9. 4755dave

    Avadexer build.....my way

    No That would be illegal
  10. 4755dave

    Avadexer build.....my way

    I have used that type of machine. In my opinion they are shy of airflow. The product takes a good while to reach outside of boom. I also want to be able to spread wheat as the other autumn I spread over 250 ha. In a wet autumn it was a lifeline both for me and my customers
  11. 4755dave

    Avadexer build.....my way

    Hopper coming too. Bigger in reality but hey ho. Capacity is good. I wanted 75 bags of Avadex capacity. I reckon I'd get 100 in
  12. 4755dave

    Avadexer build.....my way

    Hmmm small bit of massaging and it fits
  13. 4755dave

    Avadexer build.....my way

    Hmmmm Marking this to fit..... I need more tea
  14. 4755dave

    Avadexer build.....my way

    Hopper bottoms ready to go on main hopper tomorrow
  15. 4755dave

    Avadexer build.....my way

    I used to use autocad many years ago. Never did 3d as it was fery new and expensive
Top