Recent content by Agri–Mechanics

  1. Agri–Mechanics

    Unimog u1000 transmission advice please

    Just been reading I think it may of come from the u406 German army had them fitted and coukd pull aircraft or train carriges I've just looked at photos again I wonder if he lined the transmission pump up before installing first time would this cause it to be hard to spin one way and not the...
  2. Agri–Mechanics

    Unimog u1000 transmission advice please

    It starts fine without this box attached I think it must have a transmission pump in it not sure if forward reverse packs are in it or in the gear box my knowledge is limited on these and not sure what would cause it to spin ok one way but not the other
  3. Agri–Mechanics

    Unimog u1000 transmission advice please

    I went to do a job on a case tractor on a farm and wound up taking a look at his unimog u1000 whilst I was there. Initial complaint was that it was slow to turn over and would not start long story short ended up removing the starter that was fried took out the clutch and the drive in front of...
  4. Agri–Mechanics

    Mitsubishi mt21 parts

    I'm looking for a crown wheel and pinion for a Mitsubishi Mt 21 compact tractor and struggling does anyone have any idea who deals with these or breakers that may have the parts I need thanks in advance
  5. Agri–Mechanics

    Massey 8110 gearbox were doing

    Joys of being mobile all our work is on site we had to resort to saw dust in the end though 😃
  6. Agri–Mechanics

    Massey 8110 gearbox were doing

    If your sat on tractor pump us located on rh cover on gearbox just behind the selectors it has a cross over tube that runs across to other side
  7. Agri–Mechanics

    Massey 8110 gearbox were doing

    Were stripping a Massey 8110 after it's broken a synchro gear on low range that's managed to few it's way through 4wd transfer box and output shaft gears nice little job but I'd love a simple service just once in a while
  8. Agri–Mechanics

    David brown 990 trans clutch won't disengage

    Found theproblem looks like the pins under the arms had sheared off only one was still in place so no tension on the plate new pressure plate ordered
  9. Agri–Mechanics

    David brown 990 trans clutch won't disengage

    I tried adjusting the free play out of it at the slave cylinder but ran out of rod it's almost as if the clutch is compressed but don't know what would cause it I'll grab some pictures today once it's split again at least it's quick to split
  10. Agri–Mechanics

    David brown 990 trans clutch won't disengage

    Hi ace no clips the three fingers on the outer pack hold it all together with a few short bolts around casing
  11. Agri–Mechanics

    David brown 990 trans clutch won't disengage

    We've just picked up a clutch job on a dB 990 someone else stripped we've put a new transmission clutch in it and refit however it won't release. The fingers are pushed in when the clutch is off and there's a massive gap between the clutch fingers and bearing it only just contacts the fingers on...
Top