Recent content by agrotron

  1. A

    N/H6020 slow to get going when cold

    Interested to see what people suggest as I have a t6010 that is similar. Sluggish on the road for first few minutes then goes ok.
  2. A

    Tm150 roof hatch removal

    Trying to take a beacon off the roof and need to get the access panel off. The usual nothing goes to plans and can’t get the screws out . What is best way to get these screws out on Tm150. Some one has been at them before me and rounded them off and the other won’t budge. Thinking of welding a...
  3. A

    T roof removal

    Trying to take a beacon off the roof and need to get the access panel off. The usual nothing goes to plans and can’t get the screws out . What is best way to get these screws out on Tm150. Some one has been at them before me and rounded them off and the other won’t budge. Thinking of welding a...
  4. A

    Stock fencing prices

    8ft 8inch creo strainers £38 now so cost of fence depends how many turns in it. Had a short 75m length taking 7 strainers price per m not possible. Every job is priced individually.
  5. A

    Head gasket repair stuff

    I put some steel seal in a l200 pick up that was blowing the water out of the expansion bottle. System was pressuring quite badly. Followed the instruction and put 2 bottles in as the amount required depends on the capacity of the cooling system. Was suppose to be short term measure but it was...
  6. A

    Post bumper on digger or tractor?

    I got both a P230 on the tractor and vector model 6 on 6 ton digger. Tractor knocker is best for strainers. If the job is big enough I knock strainers in with the tractor then tension barb at the top and sting line one the bottom, set the posts out then track along knocking them in. I generally...
  7. A

    Deutz Agrotron rear brake 115 mk3

    I had a 1997 agrotron 6.00s. Had problems with the brakes. Seemed to lock on sometimes going down the road. If you turned the tractor on and off they would be ok. This was @6000hrs. Ended up selling the tractor and in ended up going to Romania as nobody knew what it could be without stripping...
  8. A

    Steel price

    Cladding market is strong for next year, don’t expect the price to drop anytime soon. Been told it’s going to be strong for next 2 yrs
  9. A

    Road legal LED headlights

    Just fitted these to my tm. Quite a bit brighter than the originals and combined day light running lights.
  10. A

    TM 150 2002

    Nice to know the tm150 has a good reputation as I bought one in the summer. 2002 with 9000hrs. Using in hedge cutter and flail mower. So far so good.
  11. A

    Which hedgecutter

    McConnell pa50 would be ideal for your tractor.
  12. A

    GOOD VALUE TOOL CABNET?

    I got the older model and has been good. No complaints, well made and competitively priced.
  13. A

    Hydraulic hoses.

    Called in to have a couple of 1 inch pipes about 2ft long made up to replace a burst pipe on the hedge cutter. Took the old pipes and he made them up while I waited so good service. I wasn’t in a rush so would have collected next day if required but they had nothing else to do so made them while...
  14. A

    Case cs110 pro problem

    pto switch on the mudguard. Take the connections off and clean with wd40.
  15. A

    Griffith trailer wheel studs.

    How many do you need. I bought a pack of them earlier in the year and may have a few spare which I could sell.
Top