If i remember correctly the little plate behind the valve in the picture should flick into place to hold the valve open to cycle the ram it may not be moving freely .
I have a kuhn 5060 bedder and it wont always operate some of the functions . It will always work the bed and back door that work off the small valve block but the shoots etc on the large spool block don't always work the solenoids light up to say they are operating . Is there something worth...
I dug in a field to open a quarry a about twelve years ago and the planners rang me up after it was reported to them and they said no problem as long as i was using on farm .
Look at a hydraulic beaver tail Kane , Jpm and M4 make them . Low loader is ok if that is all you want to do is move a digger but ramps up the back can be a pain on bales doesn't allow for a bit of over hang if bales are a bit long.
I'm not sure about your model but on the older 980 the gearbox and back axle are different .I know someone who took both drain plugs out to drain the oil out but only refilled the back axle and knackered the gearbox . I think the gearbox has a level plug on.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.