Ayd1988's latest activity

  • A
    Ayd1988 reacted to andyinv's post in the thread Cheap AGCO Novatel replacement with Like Like.
    Morning all I'm looking for a volunteer in the Highlands to test a Novatel-replacement for AGCO VDO3/VDO4 etc. Others have confirmed...
  • A
    Ayd1988 replied to the thread SIM card in Fendt with AGI 4 receiver.
    Can confirm V12 sims works on 2G , I have the 4 network unsteered sim also, and 3G has now been turned off in my area so it has...
  • A
    Ayd1988 replied to the thread Valtra WAS.
    Looks very similar set up to fendt WAS, as @Wombat says there are 2 types of sensor. One is for auto 4wd and auto diff lock the other...
  • A
    Ayd1988 reacted to cquick's post in the thread Pimp My Maize Drill with Like Like.
    This mornings project: Custom seeding discs. I need to make up some pumpkin discs ready for spring, but I also made OSR discs last...
  • A
    Ayd1988 replied to the thread Kuhn hydraulic block.
    Thanks @Mr Happy, unfortunately not been able to get a hydraulic schematic diagram as of yet. However local dealer can get the new block...
    • IMG_5455.png
    • IMG_5456.png
  • A
    Ayd1988 replied to the thread Kuhn hydraulic block.
    Yes very badly corroded, have just bought the spreader, I knew it was bad before buying but didn’t realise quite how bad it was, and...
  • A
    Ayd1988 reacted to Tractor Tim's post in the thread Kuhn hydraulic block with Like Like.
    Try flowfit hydraulics think it was Daren who seemed to know his stuff on valves
  • A
    Ayd1988 replied to the thread Kuhn hydraulic block.
    The valve block controls the disc speed via a couple of PWM valves as far as I’m aware, have found the part number for the 50.2 valve...
  • A
    Ayd1988 posted the thread Kuhn hydraulic block in Machinery.
    Hi would anyone on here know of who makes the hydraulic block for the 50.1 H EMC W fert spreader. Have phones dealers and they say it’s...
    • IMG_5430.jpeg
    • IMG_5428.jpeg
    • IMG_5427.jpeg
  • A
    Ayd1988 reacted to AlanT's post in the thread Fendt varioguide upgrade to RTK with Like Like.
    Just need to get your Fendt service man to come out with his laptop and unlock the existing software, obviously at a cost. Can’t...
  • A
    Ayd1988 replied to the thread Hard to start fendt 820.
    I had the same problem a few years back with my 820. It pressurised the fuel tank, and could never got to the bottom of it. Had...
  • A
    Ayd1988 posted the thread Fendt varioguide upgrade to RTK in Precision Farming & GPS.
    Hi have recently bought a 724 S4 it has a Novotel smart 6 receiver in the roof and the VD03 controller, currently have EGNOS and an...
  • A
    Ayd1988 replied to the thread Topcon agi 3 problem with calibrating.
    I have had the same problem as described above so took the AGI -3 apart today, the battery is on the bottom side of the main circuit...
    • C5106C25-4290-4248-9A0B-5D9FEBD8B472.jpeg
Show older items
Top