Recent content by Bealy

Hi Anyone any ideas how to stop rats climbing the diagonals into a grain store. I've put 15" pieces of tin around the diagonals at a perpendicular angle, however they seem to be able to get over these no problem. I don't really want to use sticky pads as this seems quite high maintenance and...

Thanks, just looked and he actually lives in our village!

Does anyone know who could repair a 20' X 20' roller shutter door in the Malton, North Yorkshire area? Thabks

Renn pto mill, 7'6" wide, 7' long, 8' high Loading/unloading at both ends LE12 5PH to YO17 9PL Thanks

CM15 0LD to YO17 9PL Needs to be shifted by 14th December. 2.2m x 2.7m x 2.2m, forklift at both ends. Ta

Where was that from please?

We were already working for nothing @£220/ton

Use 4 core, quite a bit cheaper. The armour can be used as the earth..

Just a quick update.. I spoke to Ben from Vantage (as comms) today, he sorted me a software update and a trial of rangepoint. It works perfectly now, brilliant service from him. @Tractor Tim thanks for the recommendation!

I'm not sure how to do that, on 'Satellite Status' none of those are are listed, I'll ring up vantage tomorrow and see about an update. Thanks

Thanks, ill give them a try, although I didnt buy it off them. Tried it outside away from shed, still no luck.

Hi, Ive just bought a new to me Trimble FM750 and I can't get green signal, only two bars, yellow.. It's a 2014 screen, v7.35 on WAAS (no glonass), its seeing 10 satellites or 13 if set to use uncorrected satellites. Obviously today was very overcast, dunno if that makes much difference. Any...

Did you run it with the same shares and how do the DD boards compare to the older ucn/ransome boards do you know? Thanks

Hi, does anyone know can a 140ma be turned down to 12" and has anyone used DD boards at that width? Thanks

I've tried this and can't get them to upload.. do they need to be in PDF?