Recent content by BigRed69

  1. BigRed69

    Massey 6170

    Ok thanks for the advise. I guess electrical issue so hopefully something simple to fix
  2. BigRed69

    Massey 6170

    6170 starts in 4wd until turns off at speed but just have tyre marks on concrete coming out of shed at low sppeed which the 390 just goes over leaving no marks which is odd but just curious as to why.
  3. BigRed69

    Massey 6170

    Drive 390 over concrete leaves no tyre marks but 6170 over same concrete leaves marks. Is this normal for a bigger machine to do this. Just curious
  4. BigRed69

    Massey-ferguson 6170 dynashift n reg

    Turn ignition key and D is on. Turn engine on and A and D flash together. Just starting doing this today and not sure if easy fix/solution.
  5. BigRed69

    Massey 6170 n reg

    Thankyou I will check. Also another issue I cannot get the pto to engage when I turn the yellow knob now
  6. BigRed69

    Massey 6170 n reg

    Another issue. Turned on tracter and will only go in reverse. Computer off. Yused to show bad sums but now completely off
  7. BigRed69

    Massey 6170

    Thankyou for the muchly appreciated advise.
  8. BigRed69

    Massey 6170

    Thankyou. Will check now. Also fuel guage is on red but half tank filed up. Would this mean fuel tank sender which has 4 volts on it need replacing the whole part
  9. BigRed69

    Massey 6170

    Excellent thankyou, I will ask their advice Also more advice please as I am trying to locate (as it says in my op manual) the part 25 brake switch. Does this mean brake like switch, brake pedal switch,hand brake switch?. Which one am I looking for. I just would like to check if working correctly.
  10. BigRed69

    Massey 6170

    Does this possibly mean like a computer to turn it off and on again or change the batteries in it to reset it. Or is it a bad wire that the computer cannot read the data correctly from. Hoping something I can have a go at fixing.
  11. BigRed69

    Massey 6170

  12. BigRed69

    Massey 6170

    I am trying to figure out after jumping into my cab and turning key, the data display says bad checks on it now. Hoping someone could enlighten me to what this means. I guess a electrical fault somewhere on machine but not sure where to start
  13. BigRed69

    Massey Ferguson 6170 Dynashift

    Thanks for the info,very grateful. It seems much to check on electrical more than mechanical side, which I was thinking it might be.Fingers crossed.
  14. BigRed69

    Massey Ferguson 6170 Dynashift

    My tractor has a couple of issues It's now stuck in 4wd and cannot get it out back into 2 Also now stuck in hare mode and lights showing both on dash are off. Hoping something simple which I can try fixing
Top