Kent livestock farmer wishing to relocate to south west (Devon, Cornwall, Somerset). 100 acres plus, good sheds/yards, secondary accommodation and main services. If you are considering selling now or in the near future , please get in touch.
[email protected]. All replies treated with...
Looking to buy a cattle sliding race gate, seen one made by Kelfri but as they have no dealers in the south east and therefore cannot have a look to see if it will take the usual punishment. Any thoughts recommendations.
Have had merlo on and off over the years and there paintwork used to be one of the worst, however they appear to have addressed the problem by a, the actual paint/undercoat and b, there are now no square edges where the paint used to lift.
Have straightened it out now , via cold press and a bit of abrasion with angle grinder and lube. Fairly pee'd off about it especially as tractor only done 350hours. General consensus seems to be that sh!t/dust and bad design is the problem. Will watch it like hawk in future.
Mf 6714s was power harrowing, went to drop Harrow off and couldn't lower, then noticed lift rod inner bent. Phoned dealer who reckoned sh!t/mud trapped in rod, had a look and clean as a whistle, anyone else had same experience and would it be ok to heat up and straighten or would it weaken rod
Mf 6714s linkage buttons sometimes work sometimes don't, have to keep switching off and restarting and sometimes lucky the 2 lights will flash when pressing. Driving me nuts, any suggestions like resetting computer maybe?
Have just had same thing with kubota Rtv windscreen, was open at the time when one of the hinges came loose, windscreen dropped and shattered. Main dealer just quoted £725 +vat
This is just taking the pee, anyone know mobile plant glass fitter in south east
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.