Last year I chopped a thick winter oat crop with a TX68 (not the best chopper around). Make sure your blades are razor sharp. Min tilled it and drilled wheat. I had to drill at a steep angle to the combine, and made sure I got it in before it got wet. In November it looked horrible, all...
Couldn't leave it, had to have a look.
I put the convertor on, pushed down and there is about half a mm play. Maybe enough to rattle? At the moment, that's all I can think to try, but it's nice to try something...
Thanks @ACEngineering
I looked through filler plug and all teeth look new, as do splines on pump. This makes me think my box is fine.
I had the converter off, I split the boxes on the machine, and I'm no expert on torque converters. I do remember seeing some wear on a shaft, so I will have a...
Correct level, unknown grade. Was told it was dealer serviced. I've got some genuine oils coming (going to change everything). I'll be gutted if it just needed some new oil, I was certain I was going to find a loose nut, had all the symptoms...
Hi. Got a new to me 737 130 PS at an auction (2017, 2500 hours). Got it home and noticed a loud rattle on idle. Didn't notice before I bid, the hand throttle must of been up a millimetre. It disappears with any revs. It was almost definitely coming from the angle gearbox. Doing some research and...
They're both incredibly thirsty when heavy cultivating, and incredibly frugal on lighter work. I wouldn't say there is much in it, but the JD might just edge it...
yes. I don't have a rape extension header, so cut as high as I have to to get the stuff in, sometimes just skimming the top off. If it's a tall crop, I can be left with massive long stalks, so I top. It makes lift a lot easier (been there, got the tee shirt with a picture of a blocked drill on...
I don't drill tramlines, put them in with the sprayer. I only use RTX rangepoint and it works perfectly, I can use the same tramlines every year. You might have to use the nudge button once or twice...
I do drill the headland tramlines though. Having a visual line when turning stops the booms...
TX68+. 1000 ac. Only lost half a day with failed idler pulley on beater. Little bit of welding and a trip to Peterborgh for a new belt.
Put some wet, green crap through her as well. Wont be changing any time soon. Everything is easily fixed, just worry about metal fatigue on something major...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.