Sorry should have mentioned it, I have already done that and the battery light does go out, even testing at the alternator it shows 12v under load, is there a sense wire that detects battery voltage and changes the alternator output?
I have an 8360 that doesn’t want to charge, I have replaced the alternator and it still isn’t charging, at idle is shows 14.1v but out any load on it at all it stops working and battery voltage goes down to just above 12v, does anyone have any ideas or even a wiring diagram so I can check the...
Hi,
Has anyone experienced a Manitou 627 blowing the fuse for the transmission, It seams to be a dead short as it blows almost straight away, I checked the solenoids beside the pump but dont have a wiring diagram and I'm not sure where else to check.
Yes the bulb goes out when switches off but it has an ignition feed so it would anyway, alternator is definetly charging so I’m thinking the wire must be broken to earth somewhere
Checked the alternator and it also works, sounds like a bad connection to me as well but there isn't any voltage coming out at the ecu either, do you know of anywhere I could get a wiring diagram or find out what inputs are required to make the lift work?
The electric lift on my TS115 has stopped working from any of the controls i.e. the lift handle, rocker switch or mudguard switches, I found a burnt earth wire on top of the gearbox and have repaired but the fault is still evident, I have replaced the ecu with a known good unit and the fault is...
I have a 7840 that the gear solenoid and lift solenoid valves r sticking intermitently and I want to clean them but unsure how to dismantle and what solvent to use?
Have tried all that, checked wiring etc., they are going up on the panel and its holding the gear on the panel just no movement just like the clutch is depressed, the only thing I have found is that solenoid num 3 has 0.15 volts with ignition on and the rest have nothing.
I was thinking that as well but I assume thats just in front of where the gear cables go in, I have checked them and they seam to be working but they other seam to switch for 1-4 and 5-8 would that be right?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.