Recent content by Cms

It's a malone, it spreads it more or less the width of it but its hard to make a tidy swarthy without tedding it out.

Good to hear. I've a single rotor rake. Up until now cut with tge disc mower, Ted it out and then rake up. I was hoping to save myself tedding, if I didn't have to.

Everything was cut with a drum mower here, hilly ground and a massey 135 with a roll bar.

Hi all. Has anyone used a drum mower for cutting silage and raked it up without tedding it out. I currently have a plain disc mower that I want to change, but I've a feeling that I'll be buying a mower conditioner. Tia.

It's does say highway alright, what were the highway models about?

The replacement filter is for a 300 series

Found the problem. There's a filter in a housing and its blocked solid. Many thanks to all who gave advice, its greatly appreciated.

4wd

Perhaps

You could be right, I'm only going by what it says on the bonnet

There isn't a steering ram in front of the radiator, there's 1 on each side onto the axle. There isn't a dipstick or oil level gauge atvthr door frame. It's an 8x2 transmission. It looks more in common with a 290 . I get a few photos later.

Unfortunately the steering won't move and the loader hasn't enough power to lift the tractor off the ground.

It's not a torque converter if that makes any difference.

Hi all. I've changed the back end oil and put in a new filter(genuine) after the hydraulics became very slow and the steering non existant. However this has not improved the situation. The lift arms won't go down ,no matter where the quadrant levers are set at. The loader barely lifts or...

Often it the flue is marginally higher, it prevents downdraft. We try and terminate the flue at least 12" above the ridge, if this isn't possible an anti downdraft cowl.