Recent content by FBain4532

Yes I would totally agree that its software /settings.

Anyone got any experience with an UF2002 with integrated front tank and how it works. Thinking my 2nd hand sprayer isnt quite right. So when I'm filling it transfers to the front, but only stops transferring to the front once it reaches a critical fill point of 1600 litres not at 1500l , then...

Hydraulic auto reset, transport wheel, press arm, discs.. a 6155 wouldn't look at it. will lift it but not all the way, will tho with a jerk of the brakes to help throw it up. Lift capacity reduces the higher you lift with the geometry of the rockshaft and toplink.

6 furr plough, can lift it but only just, a little more would help

Yes and toplink in the top hole

Anyone got any ideas how to make a 6215R lift a little more, pump can't be tweaked like the 30series as far as I'm led to believe.

Policies I run No pets in tractors, Must get 8 hrs sleep per 24hrs No riding on steps of tractors No lifting person in the grain bucket Nobody in standing about in sheds when forklift is operating.

http://www.agra-gps.com/product/itcextend.html

I've ordered a bridge hot wire unit from Agragps so will see how well it works on autosteer.

I've had an ITC doing coverage the past few days when ploughing in furr, the coverage is pretty accurate so yes cant see any reason why it cant be used for autosteer when say sub 30cm accuracy is all thats required.

Ram end looked fine when it was bushed but now wondering if it is slightly splayed in the back of the hole. Done all the bushes in the links tho there is about 6mm gap at the side of the tilt ram in the cast link, could this link be spring slightly? Forklift does get a sore life loading...

I've a manitou 634 that keeps breaking the pin on piston end of the tilt ram.. Bushes have been replaced 7 months ago when it broke the last one and yesterday it snapped it again.. it is noticable that the pin is bending in the fork linkage before it breaks. Any suggestions?

Yes would only be fine the likes of fert spreading on grass.

Agra-gps make a hotwire box to trick the screen into thinking it is getting an SF1 signal so will allow autotrac. £500 was the price I was quoted

The current set up is becoming a clutter with recent add on's and feel PLC with the ability to remote monitor would allow use to reduce labour requirement, would rather have the existing plant running 24hours a day as opposed to spending £200K upgrading drying plant capacity.