Recent content by del_boy

How much is that sim per month @Andy26 is it a contract or a monthly rolling one you can cancel whenever

Bought 2 tractors off him. Very genuine. He even bought the 1st one back off me when i bought the 2nd without even seeing it. Always nice well presented kit and he stood my his 3 month warranty offer aswell

Depending where your problem is. Need to do some more fault finding before splitting it. There will be some test ports you can plug into to test pressures but you'll need to know what they should be 1st. Ive only split a tsa135 to do the clutch packs for gearbox and that was simple enough

Normally problems are its stuck in 4wd due to an electrical fault such as a brake light bulb gone or switch failed as its fail safe 4wd. The solenoid requires power to keep it out of 4wd. If its clicking in ok your problem might be the 4wd clutch pack is possibly slipping and the plates worn maybe.

If you have the operators book look in there and you might find a another blanking port that might be usuable maybe underneath. Think the one the opposite side is to do with the ls line

I think you will need a t piece to go in the line 👍

Pretty sure its one of these. Have you a front loader fitted that's already using a return? Have you got the operators book it definitely tells you in there

@Colliedog is the accumulator guru

Bit of an update. I edited the code on 1 nano to say use pins 14 and 15 to output and on the other nano i edited to say use pins A0 and A1 to output. I can confirm that both these codes work and i now have 12 switchable pins and they all activate a relay now. Ive bench tested a 8 relay board...

I wasn't sure about which pins are what. In the code they are just numbered but on the nano pin D4 is the 1st usuable pin but i believe nano pin D10 is actually pin 1. Was expecting the coding to say something like d4 output d5 output A1 input A0 input etc The picture of the coding is showing...

At the start above the 1st line for pinmode 1

All ive done is altered in the code to use pins A0 and A1 (as the 1st picture) Im thinking theres something else i need to alter possibly. (Possibly in the section picture) While at home testing with a multimeter the pins are switching 0v to 4.6v but not actually triggering a relay

Well ive made some progress. Got the 2nd 5v relay board fired up home and connected it all up and everything works. Had all 8 sections switching tidy in any combination. Tested the rest of the nano pins and ive now got 10 outputs auto section controlling. The last problem i now have is the 2...

My next step when i get a minute is to flash another nano with the original code and connect the nano to a blank relay board to test . How can something so simple turn into a headache 😠😫

Will this lm2596 module as pictured help me in my case with the stray voltages im getting from the nano?