Recent content by diesel druggie

Was there ever any luck with getting a foundry to manufacture a share for these. I know of an unused one that could be made available

Replaced ram on right hand side of the krone, as it had started damaging the piston due the to a ring breaking internally. My problem now is getting the mower to lift up evenly. New ram won't fill up with oil. Anyone else come across this before. How do you fix this problem

I'm thinking this is to assist the judges when they are looking at plots for different aspects. That way all the plots would be compared with ploughing in the same direction.

What happened to the Mitchels from Scotland they don't seem to be on the scorecard. Did they not compete

Just to say the Irish are going well again We'll surely have the 2 champions on the one island.

How would they have qualified to he there. I presume they both won their nationals. In that case you would have to send them I presume.

Bad earth I would sat. Try for water in the back indicators it can get in and can stay there. I had to drill a hole in the lamp to let it out as I had to keep replacing the loom.

Any idea on the cost to do them. If an unused one could be located

Anybody know where these replicas were made. Surely somebody can make a better one similar to the original

If these are the same ones as I think they are you will need a bit put onto the land side down near the tip of the point. Also you might have to grind a bit off along where it sits with the board. Can't figure out how they would be made wrong but th e re you go.

Would you not bring them back. Maybe get your old ones done up.

Thanks for the info

Can you convert to power brakes

We have a 6506 too. I was wondering how you would go about giving the brakes a better feel at the pedal. Something like a 6610 power brakes I think they call it. Perhaps it cannot be done.

Where did they come from.