eomachinery's latest activity
-
EHi all we have a Jcb 520 2002 with a perkins 1004 - 4T engine in it. It'll start and run fine until warm (around 5 minutes) then just...
-
Eeomachinery replied to the thread perkins engine trouble.Hi there did you get this sorted, we have a loadall doing similar. Thanks!
-
Eeomachinery replied to the thread Jcb TM310 boom not extending.Hi David I don't think so, when I finally got it into calibration mode the boom comes right out, but it won't finish the calibration...
-
EHi All Got a tm310, the boom only extends about a meter but no further, comes back in fine. You can hear the Hydraulics cutting out...
-
EHi all, having trouble with an mlt 627 2012, mainly when the machine gets warmed up the brakes bind on, they bind on more when turning...
-
Eeomachinery replied to the thread Claas dominator 105 hydrostat problem.What was this in the end thanks!
-
Eeomachinery replied to the thread Manitou MLT627T boom fault help!!!.Thanks ACE much appreciated, I'll have a go later on!
-
EHi all, got a 2012 MLT 627 TURBO, when trying to boom out the boom only moves out around 1 ft at a time before stopping, then you have...
-
Eeomachinery replied to the thread Mf 8925 shuttle problems.Hi Steve I'm not sure on the heat sensor but some machines go off the coolant temp sensor usually on the cylinder head of the engine. I...
-
Eeomachinery replied to the thread caterpillar th220b.Did you get this sorted in the end buddy, we have one doing the same, many thanks!
-
EHi All we have a cat th220B which has lost its boom (joystick functions) red exclamation light flashing on the dash. It did this a...
-
Eeomachinery replied to the thread Manitou telescoping boom fault!!! Please help.Hi Martin I'm not fully sure but fairly positive that you have to take at least 1 boom section out to do the pipes, if you can get boom...
-
Eeomachinery replied to the thread Manitou telescoping boom fault!!! Please help.Hi Martin not yet, so far we think the solenoids, joystick etc. Seem to be ok, going to have another go Monday. Have you done much to...
-
EHi all we currently have a manitou mt1840 in. Telescope boom won't go out, if I swap plugs on solenoids it goes out and won't come in...
-
Eeomachinery replied to the thread Manitou JSM joystick.Did you get this sorted bud? We have a one with the boom in and out playing up (similar issue) cheers!