Recent content by Ferguson165

Not sure. tractor does not have wheel slip control button in linkage panel but datatronic has the button. buttons in datatronic computer do not work either. I had the sensitivity at 5, dont really know how it should be set.

Yeah, might be. The problem is intermittent with the plough rising.im thinking i need to check load sensing pins and wiring also linkage position sensor. Could not get the linkage calibration done as the anti bounce button does not work.

Thank you, that does help. do you have the diagram page for that bulletin?

Hi can anyone take a picture from black connector? So that i can put the wires in right order

I have been studying the workshop manual, for the rocker switch wiring, but it doesnt quite match Number 7 (red) should be 10v supply 2 (white) : signal Black should be ground? There is also two wires from the quick soil engagement button? (ac13-3, ac13-18)

The middle one with the numbers? I had set at highest position. Can the draught pins be resistance tested?

Not sure, how to set them up?

Having problems with linkage, when ploughing for example, tractor starts to lift the plough. I tried calibration, but the linkage suspension button doesnt seem to do anything I removed the lift/lower rocker switch from the armrest to check it but the wires pulled off the black connector block...

Has anyone removed mf 6400 series cab roof lining? Does it fit from the door or does it require windshield removal? No sunroof.

That was ebay listing, but pictures did not work, so wasnt sure. I did some cross referencing (MAN part numbers) and found out 384mm open and 325mm closed. Google cb0200 lenger. The ones fitted now on the tractor, are like 290 fitted and the mounting bolts are 16mm

I may have found some specs for cb0200 380mm between holes and i guess 329mm fully compressed

Picture of the current setup, as you can see not much room for travel under the bump stop? Probably 15mm...

Hi what is the length (eye to eye) of massey 6465 original cab shocks, i have some valtra ones with springs fitted, but i think that they are too soft and maybe too short , as the ride is very uncomfortable. Feels like shocks are bottoming out and bouncing back up very fast

Couple more questions, when i start the tractor there is brief growling noise from the hydraulics. Is this something to worry about? Could come from booster/charger pump? Also when linkage is in the anti bounce position linkage shakes briefly?

Yes, that was it. Got the tractor working, and thank you ih1455xl for the earth points, i have to check them, wish i could find proper workshop manual. I need to clean the tank, hopefully not diesel bacteria