Company law is enforced by civil litigation. You have to sue them, etc. In all fairness, these things get resolved, as it is expensive litigation. There has to be loss really. A director is not allowed to have a conflict of interest.
I wouldn't possibly share your information, though you aren't possibly bound by the director's fiduciary duty. Give this fellow a call and see what he recommends: www.BoardroomResolve.com
It is quite a complex area of law. As far as I know, by default, a shareholder is not allowed to view any documents with regard to the company's operation - only the directors are. A shareholder can only see the final accounts. You would need to review the articles of association, as well as any...
Can be anything when it comes to MS and Office. I don't know how Farmplan handle Office but it might be worth trying to do a recovery install on Office. Install Office again and it should ask to do a recovery install (not 100% sure on this - been a while.) Either that or Google it (recovery...
Thinking on it was a spring that goes over the shafts with a square end on it. Doesn't need much wear to not engage, or disengage if I remember correctly. Certainly an easy thing to try.
There's like some cir-clips on each seed roller that acts like a clutch to switch each roller on and off. Not difficult to change and you can't tell the difference between an old one, or a new one but the rounding of the edges makes them not engage and disengage perfectly that maybe giving you...
Ask your dealer. I assume we are talking Trimble? In the GPS settings you should find a setting for something like quality and by default it will probably be on accurate and you want Availability. Sorry I'm not sure which, or where but on a Trimble screen you'll get a GPS signal, as a set of...
Off hand no but there will be a info or status button that will give you info like sat numbers and all manner of current settings like this. You need to see what angle left or right the thing says it is at. Been a while since I've used a 750. Sorry. T3 cal doesn't take long and I think you can...
Yes sounds maybe a setting. Double check aerial is centre to wheels and do a roll test so it calibrates for tractor lean. Once done create a line and autosteer up it and turn around and do the same to see if on the same line without using the implement. I think it is probably the roll. Might be...
Stoxs is probably right.
You can do a quick T2(3) calibration. Only need to do a roll check and not all the rest of the calibration. Once done you want to check the implement draft (pulling left and right). See which way it might be pulling and enter half this distance into the implement draft...
This last year was a pretty stable year for grain input. Unstable is where most auto systems fail. Just been talking to http://smart-tech-control-systems.com, as he's just up the road and sounds interesting as uses similar logic to me. The moisture sensor also sounds good and more importantly...
Sounds like Z-tech did an observe and create look up tables as to do what and when. I think Law Denis did the same with their more expensive controllers. Problem is this doesn't work with different driers and can get expensive to do really.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.