Our pressure washer works fine on cold
If we use heat it will run hot until it reaches the correct temperature but when the burner cuts out the water stops a few seconds later .the red spanner light flashes and you have too switch off then on again and it runs until thermo cuts it all out
Any...
Ok I don't know much about the machine I was just asked too see if I could sort the issue so maybe it is bale size long and short it turns off at 115 thanks for all your replies so far
The baler computer is set at 125 density but turns itself off at 115 every time.you have to switch it back on generally put net in on auto but doesn't always retract it?
Ok old thread I know but another 644 here the control box shuts off at 115 density every bale then we turn on again and it ties at 125 any idea what's wrong with it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.