Hi, I have a puma 155 and the suspension accumulator needs changing. After reading this thread I am interested in upgrading to give a better ride. Contacted hyquip about supplying accumulator but theres are 1/2 inch female thread, where can I get an adaptor to fit my vavle block to connect up...
Panels held on by normal clamps to steels but welded them as well incase they spun, was going to put a plate over the top and down but didn't bother. There is solid rock all around so only backfilled about 18 inches so should be ok. Only wanted to make an edge between floor and wall. Panels are...
When I did my clamp I put the rsj's slightly off plumb (x degrees off plumb depending on fall and length required) an put the panels onto weld on plates at the correct height. Then when floor was concreted let the concrete flood under the panel and up about inch or so to seal it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.