Recent content by Jimmy 91

Only had it a year but was well maintained before. I'll take a look at them

Will do , ita currently put away from frosts so will try this next time I get it out , cheers

Have to constantly adjust tilt to get it to run level

Has anyone found any beefier springs to put on to stop swaying ? Ours is slightly different as it's on slate self propelled... not braced it yet as the pumps mounted on back so be tight to brace it , it's had new shocks but thinking of some stronger springs

Did you find out what oils went where ? Going to give ours a good service and check over tomorrow

Pricing parts up tomorrow and getting them ordered , seen a recond exchange box for 4250 , depends on figures weather it has one of them fitted so machines only down for a few days instead of weeks

West was result on this got exact same fault on my 2009 735 120 PowerPoint, just put a reverse valve on today and wasn't that

Had a look tonight and the setting was set at 10, reduced it to 1.5 and it seems to be hitting the target rate much better now ... I just need to calibrate the flow meter to check that's not been altered either . Thanks for the advice so far... no doubt ill be back for more 🤣

No I haven't programmed it before , got it mid drilling and couldn't get it to work in auto so just sprayed in manual to get sprayed up then been busy with other stuff since , I need to spend a day on it and get my head round it . wanting the auto working more for liquid fert in the spring so...

Thanks for the advice and manual, I will see if I can make some sense of it

Tried that , all I got was bought as seen, and there fitters don't know what they've done , thought I'd try on here to see if anyone knows to try save a few hundred pounds as it must only be something simple

Not the beat computer to use I noticed , it helps if you know what everything needs to be set at 🙈 anyone have rough settings please

Unsure what it's had through it , iv had alot of stuff through it and its still the same

Seems to work fine in manual until you run it in auto

I'll have a look at that setting 👍 ita frustrating as it was perfect before . When they was testing it it took them ages as they struggled to get pressure up so they messed about with box when it only needed ramsy valve blowing up