Recent content by Jinty Mcginty

  1. J

    Reekie 350 webs

    most off the time its a side sloping field :(
  2. J

    Reekie 350 webs

    Side plates are pretty good order and straight i measured the center belt and it was nearer 70mm Plating would be cheaper than another web
  3. J

    Reekie 350 webs

    Any one know what the belt width on a Reekie 350 first web should be originally .Having bother with stones getting in the bed between frame and web .Gap between frame and edge of belt is almost 30mm remaining width of belt about 52mm Annoying thing is bars in not bad nick it a 36
  4. J

    Portadown to Scotland

    Looking to get a pair of forklift forks from Portadown into Scotland Forks are 4ft long
  5. J

    Northamptonshire to Scotland

    Looking to haul 2 forklift forks from Brackley into Scotland Forks are 4ft long
  6. J

    Grammer Seat fault

    Grammer seat sitting on its arse won't pump up Checked fuses OK pulled apron of put 12v straight to compressor fired up right away but weird thing is that there is 12v at the pump connectors when you pull the handle but pump does not fire up Any suggestions?
  7. J

    Loadall hydralic fan motor

    Sorry about the quality of picture part No is 20/925660
  8. J

    Loadall hydralic fan motor

    Does anyone know the make an model of the hydraulic fan motor on a 536-60 its a reversible one. It is leaking at the output seal and spattering the engine in oil. Has anyone tried rebuilding one.i presume if the seal has gone it's down to wear in the internals Thanks
  9. J

    Find the Nipple

    I find cold weather and draughts makes it easier
  10. J

    Jcb 536-60 Boom Lights

    Utv ones on the boom
  11. J

    Jcb 536-60 Boom Lights

    Thanks for that Even a picture where the cable goes into the cab would be good
  12. J

    Jcb 536-60 Boom Lights

    Thanks a picture is most helpful Have you any idea how far into the cab you have to go to pick up the connector that's hopefully ther waiting I assume its there as there is a fuse and relay already fitted
  13. J

    Joint ill lambs

    Yes being doing it for some time
  14. J

    Joint ill lambs

    Thanks for all the replies very informative. Never realised that metacam along with the AB is important as well . We are very particular about keeping the lambing shed clean and dry but not so easy at the peak of lambing.We don't actually dip navels but spray instead another entry point could be...
Top