Morning all,
I have an nc3000 which got a replacement bottom bearing some time ago. But lately there is a rattle/vibration up at the top around the gearbox. Is there another bearing on the gearbox in these agitators ?
Thanks
Tm120 here with a slight fuel pump tweak pulls 2500 tanker here with slurryquip db. I use 5 spools. No issues pulling maybe on wet hilly ground you have to be a bit cute but when dry no problem at all. Running on 900 tyres but wouldn’t want a smaller tractor tbh
if you are after a new macerator only, these guys make them:
https://truflomacerators.com/
They were mentioned in another thread already.
I have no affiliation with them and haven’t used them but some tank manufacturers are using them
How are you finding the slurryquip for lumpy bales of silage?
I mentioned it on here before but mine does block with a bad lump of silage I know they are only made to handle what passes through the animal but I often wonder is it my hyd pump isn’t spinning the mascerator fast enough
I’m after ordering this welder for farm use and a set of 6013lf welding rods:
https://www.ept-irl.com/products/parweld-xts204-220v-inverter-welder-200amp-mma-wtwtwpw-xts204.html
it was a shot in the dark to be honest as I want to know how to weld
Anyone have one and how are they finding it ?
Mine didn’t come with a manual.
No stickers about psi either (well apart from “check tyre pressure”).
Keep your nuts tight and your dripper lubed is all I honed in on on that big yellow sticker 🤣
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.