If it’s same a x60.40 3/4 selector won’t be properly in neutral therefor won’t let it out of 2nd gear either try moving the linkage under cab or take the gear stick rubber off in cab and try levering the selector back into neutral . It dosnt take much if you get it in the right bit
If it’s same as the 578 netter check the bearings on the roller with the spiral ends the net feeds round befor it goes to the pair feed rollers ... had problem with net not starting as this roller was tight to turn by hand ...
Is there any way of testing the sender to see if that is the problem other than fitting a new unit? Machine is needing a fair bit of money spent on it prior to this problem sub pins on front axle and tracked ends all round also universal joint collapsed in for hub . Do you know wither...
Thanks for reply ACEngineering
machine has just over 7000hrs on clock . where is the sender located on the transmision ? is it easier accesed from under the boom with the gaurd removed ? If you press the de- clutch button on either the boom control or gear lever light and buzzer go out for...
Hi
have a manitou 526t 2002 and transmision oil warning light has started coming on as well as warning buzzer when traveling forward . oil level checked and fine and goes out in reverse but returns again within couple yards of forward travel . has anyone had smilar problem ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.