Recent content by massey765

  1. massey765

    Volvo/pel job parts

    steve woods would be my pick
  2. massey765

    Wilson Farming Cheffins Auction

    thas bleddy nearly swearing there:oops:(y):D
  3. massey765

    Claas Jaguar - Knife Cylinder

    you used to be able to get new weld in knife mountings......done one our two after blow ups
  4. massey765

    Ransomes Bonning

    try match ploughing on face book
  5. massey765

    Ploughing in the David Brown or Ford and Fordson class at the Nationals.

    as far as i know you dont need to qualify , but will probably need an invite thro one of the clubs
  6. massey765

    Yl 44 shares

    arthur jennings 07527 066 700......they are steel and you can weld them to reprofile as they wear
  7. massey765

    Wide fit dealer boots

    i have skelerup redband...find them better and broader than either redback or blunstones...water proof aswell
  8. massey765

    Lime spreading

    i had one for about 20 years....dont think i have any photos
  9. massey765

    Why is there a big shortage of welders?

    Billy Connely did ok after he diversified :D
  10. massey765

    Dowdeswell Power Harrow rotor bearings

    i found that the cheepy chinese ones wuz useless .....rhp (y)
  11. massey765

    Ford 3000

    3 axle would be on the limit.....a check weigh would be in order i would think
  12. massey765

    Ford 3000

    there is no noticeable difference between the two...i would guess the ts86 might be slightly heavier....but i think you would be well within the 3.5 ton limit
  13. massey765

    Ford 3000

    have you rear wheel weights on yours
  14. massey765

    Ford 3000

    2.300 mk1 65 ..ts59 on local weigh bridge........ so a 1ton ifor still leaves a bit of scope for weights ect... i took mine to local weigh bridge when i changed to 7.5 ton wagon
  15. massey765

    Ford 3000

    my outfit weighs 2.300 ....so no probs on an ifor
See more
Top