Recent content by mikep

Hi thanks but I am looking for a 17" plain flat disc for another application and can't find any so I will try resharpening the worn JD ones unless you can supply those?

Thanks for the replies has anyone got 20 x 17" worn discs kicking around?

Hi. Are the JD 750 discs hardened all the way through and what diameter are they usually when replaced? The reason I ask is my drill discs are unavailable so I need to find a disc about 17" which I can then modify either the disc or hub to fit? Tia

And these

Hodmedods started these a couple of years ago.

Just to put another point about RT. I was dead against it and have already told them I'm going but.....Last year I got a contract to supply heritage wheat to a bakery, they want a lot and I cannot mill that quantity so they are contracting the milling out to one of the larger independent mills...

Hello. I have just bought a S/H set of opico grass harrows aka weeder harrows. They are fitted with 8mm tines whereas the weeder usually comes with 6 or 7mm. We are on very heavy land so the question is will the 8mm knacker winter wheat? Tia.

Has anyone any idea how much N a living mulch would 'leak' into the soil available for the cash crop. Looking to try this with heritage wheat but worried about too much N especially in the spring.

Thanks for the replies. After much testing and hair pulling it was a faulty joint on the pump solenoid wire which we found by accident! It had tested OK for continuity but in the fixed position was open. Could find no visual fault with it or the wire, no corrosion and sound crimp! Anyway trimmed...

Can you check the ecu output from the pump leads or is the pulse too weak?

After the first episode mine was twice low powered and struggling when cold but if you nursed it for 5 mins it came back fine but did flash brake fluid warning light!!. Then it was fine until today.

Put the engine in the shed as an investment and fit a hayabusa just to see what a Porsche looks like in the rear view mirror. 190hp sequential box billion rpm. Got one going in my little 1960 Morris mini sleeper.

The nozzle is usually threaded to adjust the venturi, try turning it one way or the other.

Hello. I have a Claas 656 in which today the engine just stopped dead and won't restart. Does anyone know if sensor failure can cause this or does it just go into limp mode? It's probably the ecu or pump but I just wonder how you can find which one as guessing can get very expensive. It did this...

Err no issues? What part of my story is untrue? An answer would be nice but not expected from you judging by my experience.