Monty's latest activity

along similar lines, mower designed as a mulcher was never the best cut, particularly in damper /longer grass and quite often needed to...

Welded a Claas Senator idler pulley onto the adjuster bolt on the mill rollers to make it easier to adjust them. Also welded the end off...

Old disused bucket, Cut hole in back, added some tube for the forced air, sat it in a wheel barrow and bingo, outside coke fire!

Wife didn't want deep fat frier in the house. So made a table up in the chummer from some old tyres and a mirror. Will start my diet...

Putting thr plastics back on the quad after changing the drive belt and the bolts holding the plastic to the foot pegs were so rotten I...

Howard 350 Garden rotorvator needed a new throttle cable so i used a brake cable from a scrap mountain bike..

At £7 a gallon the lawnmower is having a vacation. Calf born with no eyes and webbed nostrils and no teeth has defied the odds to still...

Too tight to go out and buy some reel/corner posts for the electric fence. Here's one I made earlier.

Plastic bung was missing from headstock of the rake. Made a new one from a pringles can. Plastic lid was a tad too big, but base just right.

I fear it’s gone beyond a bodge now, no sign of the lock so I had to cut a piece of perfectly good 5mm bar for a handle and use a new...

I was sick of moving car trailer with a strap or something so bodged this together in winter time. Don’t use it very often but is handy...

We have a couple of the 39" melco levers. They are ok but I don't like the s shaped end on them. It tends to get trapped between tyre...

Andrew you are correct, it's a pain in the backside when not on the tractor.

Found this dust cap in the return oil connection on Dad's tractor today.....