Recent content by NH 200

Initially using well water in a 30,000 litre water tank with a circulation pump running constantly during milking that brought temperature down to around 16 degrees. Added the ice builder 52 plate cooler and milk enters tank at 4 degrees, bulk tank hardly kicks in. Ice builder only runs on night...

If you're looking for a plate cooler contact Uk exchangers LTD, very competitive on price and where many Parlour manufacturers source them at a fraction of the cost. Purchased a single stage to go along with an existing one 2 years ago 52 plate running on 50mm water pipework

Drop the chute right down to the floor, undo 2 bolts either side of the drum holding bearing housing, lift drum out, then cut protruding bolt with thin 4 1/2 disc. Easier than removing rollers

If you want some good advice phone Motor control warehouse in Newtown and ask for Gareth Lloyd. He can advise if the motors you have can work on a Invertek inverter, 1st class service.

May I ask where you had these prices from as i'm currently looking for comparison with a broker or online?

Try Alutec Uk Limited Tel: 01543 500508 Direct Dial 01543 2266627 https://www.gm-radiator.com/?page=search&spartno=10284A This is a link to a rad I bought for a jcb 526, no plastic ends

We've received the same letter and wanted to contact them, who did you email within opus @DaveGrohl ?

What sort of volume and head do you require, if your looking for a high output pump look at the Grundfos SQflex 2.5-2 capeable of 2500 litres an hour upto 100m head. will run directly on dc voltage from 80-300v or run on 240vac current...

7000 litres Gas oil 0.65 1000 litres derv 1.10

Your chain has probably seized in one or two links. Remove side cover and chain then see if drive cog turns freely without chain. Replace with new chain from local bearing supplier for a few quid.

Ours is a tier 3 2011, had a new electric pump 2 years ago. Now fitted an additional Facet inline pump to make sure there's sufficient fuel but still giving error codes.

Did you manage to solve this issue? I have exactly the same problem with error code e700 coming up getting difficult to start and then stops itself with error code E133 coming up. E700 is a low pressure fault and E133 is a high pressure fault. Thanks

If you give your local motor factors a call and give them the volkswagen part no above they should be able to get it next day for around £20

The opico should be the same as the einbock which use the hatzenbichler Seeder. Volkswagen fan blower part no 251819015...

Looking for a single phase preferably or three phase ice builder 1-1.5 tons, or know of any dealers who may have any for sale? any suggestions appreciated, thasnks