Hi, would anyone have a picture or parts diagram for the connection of the stopper cable to the engine. I can’t seem to source the part that the end of the cable attaches to. It is a series 2, 7610.
Thanks in advance
All, I am trying to remove the roof on this (7961 Series 2), I am aware of the bolts on the top and hinged, how many bolts are there?
Also any recommendations for the workshop manual for this as I will be doing a few bits to tidy up!
Thanks
Grammer msg20 seat, not air operated
Not sure of the price was thinking around £120? open to offers
Suit forklift, digger, tractor
Can put on a pallet
Thanks
Hi all, I have to replace a couple of hoses, want to order on line. The machine is all metric, however, I don't if they are the light or heavy types?
Is there an easy way of telling? I noticed one of the hoses is 1/4, the spanner size was 17mm which is leading me towards the L.
Eventually got it split down. It all appears to be in good order. The pin doesn’t seem bent and the spring is ok. I am wondering did something move and the groove/slot moved from where the oil pipe was connected? Going to reassemble and see if it works
Hi the locking pin on a merlo is not springing back and have checked Hydraulics which are ok. Which leave a dodgy spring or a bent pin. I have taken the whole in out and taken the large nut off at the top but not sure how to get the pin and spring out.
What holds the pin in?
Thanks
Looking some insight into how many meters a reasonable driver and a machine can clean out per hour/per day, to clean out a watercourse. Have a lot to do and not sure how long/ how much it will cost me.
Thanks
I have a pro driven pan mixer about 850l or so. I was wondering about using an electric motor to drive ( have 3ph) and not sure the size and type of motor to run it?
Any help would be appreciated
Thanks in advance
Still can’t get this back on the road. Split the tractor, all looks good. Checked all sensors, again all seems to be ok. The valve block where you bleed at was full of dirty and have that all clean along with new filters,etc. I now have a good clutch but still won’t go into gear. Pulling hair out!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.