Recent content by PeteWithABeard

  1. PeteWithABeard

    Fertiliser Price Tracker

    Anybody got any prices for after cut fertiliser yet? 24.0.15 + S or similar.
  2. PeteWithABeard

    John deere loaders

    We have a H340 on a similar John Deere and it was only 4500 when new! two years old, used every day and still good.
  3. PeteWithABeard

    Newholland T5 warm up time

    It only takes 30 seconds on our t5 before you can rev it flat out. Think yours must have a fault
  4. PeteWithABeard

    drain jetter - pressure washer atachment

    The one we got from spaldings is good. The pipe is smaller diameter and lighter than the normal 3/8 hose used on our pressure washer. So it can pull itself down a drain pipe.
  5. PeteWithABeard

    Jd 6125m transmision air pump fault

    The dealer has now put the larger tank on. Them telling us that the handbrake had been left on was rubbish. I think it's because they didn't know what the problem was The speed of the hydraulics is another story in itself. But the answer to that question is no.
  6. PeteWithABeard

    Jd 6125m transmision air pump fault

    we had a new 6115m in march 14. When this tractor was delivered it was low on power as you had experienced. it went in and was put on the dyno and read in the region of 90hp on the pto. Some tweaking was done and was slightly improved. We have an 11ton richard western which it wouldnt tip...
  7. PeteWithABeard

    Damage caused by contractors

    It's not unknown when it's steep, for a bale to roll end over end.
  8. PeteWithABeard

    North Yorkshire to Somerset

    Just to confirm this would be from Malton to j24 m5. Any time in the next two weeks would be fine.
  9. PeteWithABeard

    North Yorkshire to Somerset

    I'm looking to get a Sutton Road brush from North Yorkshire to Taunton somerset. If any one can help pm or ring on 07816083415
  10. PeteWithABeard

    How much to swap a fat beast for 20kg topside

    I'd be having rib if I was you. Topside is not the best. Any butch would be happy to get rid of that quantity
  11. PeteWithABeard

    painting tractor tinwork

    Spray the edges and corners of the work first and fill the middle in after and Keep the spray gun moving. Have a go, It's only a Massey after all.!!
  12. PeteWithABeard

    new holland t6 sle

    I wish this was true as the gear stick is a country mile away from the seat. And the buttons on the side is located by a sharp plastic handle. The worst thing about these tractors imo.
  13. PeteWithABeard

    recommendations for a good pocket knife

    Buck bantam and or opinel no.7. Both light weight and hold an edge. Sharpen up on a concrete edge and cut like new.
  14. PeteWithABeard

    which rake?

    We have a Claas 800 with a 3meter pickup. We feel the rake is well matched to the forager. We did use it for the first season in front of a Claas 75 which had a narrow pickup and had no issues. We asked the dealer to plumb a second pipe from the ram so we use a different spool for each side...
Top