R&D's latest activity
-
RR&D replied to the thread Cooks bale sledge belt.abconveyors.co.uk Made a new floor belt for our Bredal spreader, excellent quality and a lot cheaper than original. May be worth a try?
-
RR&D replied to the thread 4255 clevis drawbar.I have a compete drawbar that was replaced with a pickup hitch off a 4350 if it is of any use
-
RR&D replied to the thread 16000 bird Big Dutchman flat deck for sale.I have a complete flat deck system that we are considering selling. If you are still looking send me a message.
-
RIve said this before but mate has the 350 ish evo metal, chop 110v . From Machine mart . He has cut many ,prob 30 , 65 mm solid pins...
-
Rthey say that review could be at least 1 and maybe 2 years away ! If they are going to carry out this theft they wont wait that long...
-
RR&D replied to the thread Looking for temporary storage space, Nottingham area.PM sent
-
RA couple of light units, an on/off/on switch, an indicator relay, some rudimentary wiring, at it's most basic..
-
RR&D replied to the thread Battery Storage worth it? £75,000 rent, 4 acres.Pm sent
-
RR&D reacted to grainboy's post in the thread Red Tractor and Grain passports - which grainstore? with
Like.
As no longer a producer, looking in from the outside, Why, does everyone just refuse to load, for a week, as the French would do, Sit... -
RYes I get your point on that one, and agree we can’t trust them as far as we can throw them. However in theory this is what they should...
-
RR&D replied to the thread building up a shaft.We had this done on a main drive shaft on the back of a Claas combine header, it lasted a little while then snapped in half where it had...
-
RR&D replied to the thread Quadtrac idler/roller.Just had a quick look at our 550 against our 9380. The 550’s are roughly 10” wide opposed to 7.5” on the 9380.
