Recent content by reboot

Theyre such a faff to fit especially in the dark. Get one of these cheap all in one instead, much better

I was pulled over for a dvsa inspection this morning, 18month old jd 6195 and vaderstad rapid drill. Their main concern was lack of a number plate at the back, am I being naive or is there a rule that soil engaging trailed appliances don’t need them because like lots of similar machines the...

Mines regening every 30-40 miles. The sensor tubes aren’t blocked but I haven’t checked for splits. on inspection the dpf contained ash but no soot. Iv cleaned the egr valve which had soot in it but valve was not stuck 🤔

Hi trev did you ever get an outcome on this? My regens are back around the 30-40 mark again. No error codes or eml lights. According to the dealer the injectors (2new and 2 original) are still in tolerance. Iv cleaned the egr valve and that seems functional. Iv had the dpf disconnected and a...

If your on Facebook there is a Sanderson forklift and telehandler group that might be able to help

Good luck. With your election I wish we could have the conservatives back they knew what they was doing. So the previous administration here was conservatives. They froze council tax for 9yrs (out of 15yrs I think) But everyone badly judged them on the amount of developments they approved...

If you’ve worn or snapped any legs, cut the leg off and you’ve got a bracket 😉

So things Iv learnt about the 2.5 isuzu d max. Check oil regulary. Don’t buy supermarket fuel. I find a dpf in every few tanks of diesel helps. Avoid short journeys ( so which vehicle is suitable for short journeys🤔) Avoid at all costs turning off or idling during a regen. Controversial but...

I think they may copy and paste the “it’s your fault” excuse. Between 60/80 -200 mile regens is apparently normal 🤔

How worn are your tracks 🤔 if their very worn you’ll get a rough ride.

If you ring 999 your phone should roam to any provider that has a signal if it’s only your provider that’s affected 🤔

Ferobide works well on the side of legs especially if the leading edge has tungsten protection. Ferobide is faster to apply than hardfacing, it also doesn’t create as much heat which can cause the legs to warp.

They was £38 when I bought the first one

Iv cooked pork loin steaks, sausages, lamb grills and steak etc etc from frozen. Somethings may take up to an hour and a half but when your in it all day non stop it’s easy. You’ll need a 30a supply though and don’t use a cigarette lighter cable wound up you’ll be surprised the current it draws.

My tractor does, road pro 12v oven, its been worth every penny and the best in cab purchase Iv ever bought