Has anyone changed the crankcase breather filter on a t5.105 / has any instructions on how to do it? Part number for the filter is #5801686484 but in the manual it says take to the dealer but i'd rather do it myself. Any help appreciated.
If any of you are interested in cheaper rates for your houses drop me a message. I work for a company that can bundle items such as electric, gas, broadband and phone into one bill and the more you take out the cheaper all of them get. With 3 packages they offer the cheapest energy in the Uk...
Hi All,
So on the t5.105 you need to pull the black handle up and click the yellow switch to change between 540, 540E and 1000 pto rpm. Unfortunatly someone has pulled the gear selector without pressing the yellow switch to dosengage the pto brake and now the selector doesn't change the speeds...
Hi All,
Got a bit of a problem with a 1.5 year old New Holland t5.105 with 24 x 24 Powershuttle hi Low splitter. Every now and again when you try and drive in II and second gear the clutch engages and the tractor moves but as the clutch reaches the top it just cuts out as if its in neutral. Has...
Great thanks for all the replys! One thing about your gates @hutchy143211 if I was using tube would a flat bar welded to all horizontal tubes be enough to brace them 40 x6) or would you have another piece of box in the middle with holes for them? Also what size plate did you use for the backing...
Hi All,
Im looking at making a swinging gate for the cattle race and I’m looking for some advice. It needs to be 14ft long and swings from a post and will be made out of square in the sides and tube horizontally. What size thickness should I go for with the tube? 2mm or 3mm? Normally I’d go 3mm...
Hi All,
I've seen a lot of information on here on putting up sheds and just had a few questions about the corner posts. How much concrete do you need in each corner before you bolt the beam? Also, how much should you fill up after? If the ground is a clay like soil do i need to dig it deeper and...
Hi All,
I Have a manitou 627 mlt turbo and I found this 12mm bolt sitting just under the main ram of the boom. Does anyone have an idea where it could have come from?? I know it’s a bit of a long shot.
Planning to do it myself and not intending to scrimp want it to be a good job that conforms to the regs. I thought swa was mainly used for underground runs this is for sockets and lighting
Hi all,
Does anyone know what cable to use inside a shed for lights and sockets? can regular T&E be used or does it need to be in conduit also nym-j cable?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.