Picture one where the tractor arm is fitted on where the bolt holds the casting on to the cross shaft from the bolt side of the casting should measure two and a half inches to the plough side casting that is for ten inch furrows .When you can get some wrap round skimmers you will find them a lot...
I know instead of pulling everybody to pieces on here and being as it is a ploughing match site lets have a ploughing match for everyone that writes on here then instead of a slanging match we could have a ploughing match . Some where in the middle of the country . God knows who we will get to...
Do not pull John Plowright down he has run more ploughing matches and raised more money for charity than anybody on here .Plus there would not have been a national match the last time it was in lincolnshie if it had not been for him.
Just got it up on you tube no your plough does not have the wheel width adjuster so you will have to get your wheel settings correct but i dont know what that is with 14 inch furrows but your front wheel wants to run in the same place as the inside of the back one
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.