Recent content by Tim

Bought a tractor from him , good man to deal with

HI A chap in keeps stuff in our yard has this which he will sell . Would like £850 . It does all move would just need a bit of re-commissioning . Pin size 45-50mm does have bushes that are 45mm .

A few from the old man’s collection of clutter !! Hopefully can see most of them

We had a building from them last year . ( livestock building ) Could not fault the building or the lads who put it up . Top job

Think when we did one we took the cool box out , only couple of bolts . Pulled the radio out and it wasn’t to stressful 🤔

Not yet ! Was going just to keep it until we got going with the new one and will then sell it

Yes , to replace the West .

Same to get it dirty

Hi Open to suggestions/ recommendations of a good long range torch for night time patrol and poacher spotting . Tia

Hi RB35 9000hrs just had Bateman do a chassis refurb before Christmas . Took it to bits and replaced everything that was required . Axles bushes , pins , track rod ends , side arms , hubs and any hoses . They also did pump drives , fan belt , hydro cable and any thing that has been modified...

Hi Looking at new muck spreader options to spread cattle muck . 50 / 50 split of yard muck and loose housed straw beds . Been a West dual spreader up to now . Looking at different spreaders and thought about going to a rear discharge , but have spoke to a local rep and he has suggested a...

We have just made some from some hard wearing plastic blocks as a bit of a experiment .

BUGGER ! At least it didn’t take the fence out [emoji34]

Hi all Can anyone identify what the name / type of hydraulic fitting this is ? It’s from the spool block on a MF 690 . It’s a swivel and is retained by a u shaped retaining clip . Tia Tim

NORBAR 4R 3/4 inch drive torque wrench new in plastic case .] £275 can post at cost