Tonym's latest activity
-
Tonym replied to the thread Used ride on mower advice.Good advice e.Had a Countax and thought it was a good mower Replaced it with an industrial Iseki. Would never go back Like chalk and... -
Tonym replied to the thread Gripwheels.I have an old Stanhay wheel strake as they were called in the back of a shed. Slacken two nuts and drive forwards to put the lugs out or...
-
Tonym replied to the thread Dynamo to alternator.May not be the dyanmo. Could well be the regulator. Alternator conversion will do away with the regulator and charge the battery better...
-
Tonym replied to the thread Dynamo to alternator.Large terminal to battery live and small terminal though ignition light bulb to a switched live.
-
Tonym replied to the thread Water run off.I have seen a track ruined by removing the raised centre to make a gutter. The centre stabilises the two tracks and once it was removed...
-
Tonym replied to the thread Westwood t1800 cutting deck won’t engage.Just forget the original system and rewire it direct from the battery to the clutch. Run wire from the battery through the seat switch...
-
Tonym replied to the thread New Holland CR 11,90.That output would almost impossible to obtain especially in an average Canadian crop of 1.5 tonnes per acre. With a 60 ft header I...
-
Tonym replied to the thread Vintage Tractor Insurance.My vintage policy with the NFU does not insure impliments attached to the tractor. They have to be insured seperately. Their farm policy...
-
Tonym replied to the thread Dominator 116 cs.I remember when I had mine combining some oats for a customer. It rained on the straw and he spread it with a haybob to dry. The haybob...
-
Tonym replied to the thread Dominator 116 cs.I had a Commander 228 for 1 season. Hard to set up as it pulverised the straw which gave the sieves a lot to do. One customer in...
-
Tonym replied to the thread Stiga Villa 16 HST.Is the belt a proper kevlar mower belt. Ordinary A or B section belts do not work well as clutches. I have a Yanmar diesel ride on I...
-
Tonym replied to the thread Fendt ideal.You can cut your hedges too with a Class!
-
Tonym replied to the thread Removing a stuck bolt.Plough legs can wear the bolt on the leading edge and sit back in the recess if you understand what I mean. Try thrashing the leg...
-
Tonym replied to the thread Generator electrical test.I think the OP means not if it is in working order but is it electrically safe. A big difference.
-
Tonym replied to the thread Combine engine.I have got a vw to vauxhall 1600 /2000cc adaptor plate if of any use. I think it would also fit diesel astra range.