Recent content by whiddy

Have a JD mower, won't start with the bonnet up! that gets you sometimes!!!

If its old fuel, has probably gone stale, drain tank and carb, new fuel,try again!

Think I just went to bearing supplier, was a few years ago!

Any TSP and MOP prices would be appreciated!

Maybe something like this https://www.sgs-engineering.com/shhp30-30-ton-h-frame-hydraulic-press

Can you not just put the LD points on? https://www.apm-supplies.co.uk/ProductGrp/trioquatro---used-on-prepost-2007-models

Try greasing up the locking pins, then put them mid way [ie no pressure either way] then stop engine. connect pipes, if that fails crack joint on pipe!!

What about Billcar engineering, must be close enough, had good service from them when I had a Navara with timing chain probs.

Sounds like a stuck valve. on my knight if the tank wash tap is open the induction bowl will not function.

Take it apart, bet there's dust in between glasss and darkening lens!

Hi Yes you need to splice a wire into the purple wire that goes to pin M. take apart the screw conector on the link cable that plugs into the back of the screen then you will see letters on the back connect this wire to your on/off spray switch.

I should have realised when the title said, tire and not tyre!!

Oh Deere! You really don't need to take the wheels off!

Old water filled fire extinguisher, make sure it has a tyre valve to pressurise, fill with oil 5/10 ltrs , 70psi air and away you go.

Have you thought about a rake and a hydraulic thumb?