Kuhn 30.1 electric to manual
- Thread starter Bealy
- Start date
- Location
- Somerset
why would you want to do that?
Got a wiring fault at the moment that I can't get to the bottom of, replaced two actuators before and had them apart countless times..
Mr Charisma
Member
- Location
- stratford on Avon
First thing I would do
35 thousand acres and no down time bar one hyd hose which only lost me a couple of hours
Always wandering
Member
What is fault linak or rohmheld actautors?
They're the linak actuators, seems to be signal problem this time though, one actuator works but if you switch the plugs the other side works..
Always wandering
Member
Not much wiring to them looms are pretty bullet proof unless damaged by top link etc have you cleaned plug into box with emery paper ? If you check set points in test diagnosis page do both actuators work
Aye cable has been damaged before, a few of the wires were corruded all the way to the black box on the spreader. Ended up running switch direct to the actuator motors just to get me going.
