harvey121
Member
- Location
- herefordshire
Mf error code
- Thread starter harvey121
- Start date
- Location
- Pembrokeshire
RTK, Trimble RTX, EGNOS?? Whats your correction signal set to use? If using RTK/X is your key still in date?
harvey121
Member
- Location
- herefordshire
It's Massey's topcon system rtx. It keeps saying GPS signal not strong enough to engage auto steer it seems to be showing satellite on the screen
- Location
- Pembrokeshire
Has tractor had flat battery or anything to cause screen to reset? Try changing correction to egnos and see if it works on that. Have seen recently a case Trimble reciever full of water, showing satatelites on the screen but unable to get RTX signal.
harvey121
Member
- Location
- herefordshire
That could be a point I've had a dodgy earth on his tractor so screen may have reset.do you know what settings should be on datatronic screen
- Location
- Pembrokeshire
Not a clue on a Massey unfortunately.
Northern farmer
Member
- Location
- North
Cannot be RTX if it is a Topcon receiver. Is it an AGI-4 (AGCO/MF variant)? Could run on OmniSTAR or Egnos or RTK.
Try to figure out a bit more about the correction format and the corresponding correction signal status.
harvey121
Member
- Location
- herefordshire
It's on rtk
Northern farmer
Member
- Location
- North
Did it just suddenly stop working or a new tractor for you?
Who is your RTK correction signal provider? Have you checked the correction signal status (messages coming at a low latency)? Robt would probably still remember the menus to check the necessary details.
Who is your RTK correction signal provider? Have you checked the correction signal status (messages coming at a low latency)? Robt would probably still remember the menus to check the necessary details.
harvey121
Member
- Location
- herefordshire
New tractor to me
harvey121
Member
- Location
- herefordshire
Ntrip
Northern farmer
Member
- Location
- North
A valid SIM card inserted to the receiver modem? NTRIP subscription valid, settings OK (IP-address, port number, user name and password)?
harvey121
Member
- Location
- herefordshire
I'll try sim in phone and see what happens thank for help so far
Northern farmer
Member
- Location
- North
I'm not familiar with the virtual terminal mode but according to the manual, all the RTK correction signal related status info does not seem to be available. One of the menus show the cell connection status. Tells you if the SIM is fine but does not tell if the receiver has registered to the NTRIP caster and receives correction data. Perhaps I just did not find the relevant page from the manual.
I'd try some NTRIP test app on a phone with the SIM from this Topcon receiver. E.g. the Lefebure NTRIP Client app for an Android phone.
I'd try some NTRIP test app on a phone with the SIM from this Topcon receiver. E.g. the Lefebure NTRIP Client app for an Android phone.
harvey121
Member
- Location
- herefordshire
Thanks for help turned out to be sim problem