- Location
- Dorset/Wilts
Cannot get the beans to flow in the header. They cut and just sit on table between knife and auger. Tried all sorts.
Is it just a bad design header?
Is it just a bad design header?
Tried the reel right in and still crap. Had the reel slow, medium, fast and super fast. Header is down as podded low but tall plants.Pull reel back as far as it'll go, little bit more reel speed, angle finger to grab a bit more and try cutting diagonally or cross over instead of up n down with tramlines. Let header down a bit more rather than leave a longer stubble and a little bit more forward speed does help it flow. Dividers and wings help if its not flowing on the outside's of the header.
Never had any bother beforeCannot get the beans to flow in the header. They cut and just sit on table between knife and auger. Tried all sorts.
Is it just a bad design header?
Are header tines on full rake?Tried the reel right in and still crap. Had the reel slow, medium, fast and super fast. Header is down as podded low but tall plants.
Tried side knife as thought was catching on side but it just sits on the front
Tbh that is the one thing I haven't changedAre header tines on full rake?
Think soHave you got a full ser of fingers on the cross auger? In the middle and helpers a bit further out?
So that would be right angle?Are header tines on full rake?
Nop,Do you have any lifters on ??
I have found cutting different direction can help, cut at an angle 45 or 90 to way u are cutting now.Nop,
My losses must be sky high already!They will just rattle the beans out before the knife.