First thing is to take a picture of the orientation of the discs for later reference,
Then unscrew the agitator, one side is left hand thread and the other is right hand thread, then remove the disc, then remove all the 6mm bolts and pry apart the two housings you will then have the shaft...
Have one of these collars on my TM 175.
Was on there when I bought the tractor years ago, always wondered was it a new holland part. Would love another one as mine is starting to break up internally now.
Anyone got a operators manual for the casetronic rds flow controller on a case 2600Lt,
Need to calibrate it but can't find much information, it's basically the same unit as a rds delta 4 but some buttons are different so it's not the same procedure as the delta 4 controller..
Replace the top seal when you're replacing the two bearings, nearly always the problem because of water ingress,
we use grey upol tiger seal when rebuilding as it's as near to the original that's available, also just for peace of mind take note of the orientation of the veins before...