Search results

  1. E

    Jcb 525-60 boom/3rd service

    Hi all, we have a 2004 Load-all 525-60, the fuse for the telescoping boom/3rd service keeps blowing, i think i have traced this back to the solenoid which switches the 3rd service from the head-stock to the PUH as the solenoid was really hot even heating the wires going to it. I have unplugged...
  2. E

    McCormick ground speed sensor

    Hi all, i've got a Mcormick CX105 Xtrashift, the ground speed is not reading on the dash, the display just stays at 0.0 mph. The dash is not the issue and we are getting the correct powers/earths to the correct pins up to the dash, so i believe it is the ground speed sensor its self. could...
  3. E

    Kramer joystick switches?

    thanks
  4. E

    Kramer joystick switches?

    Did you ever get sorted with these, im after some the same, thanks
  5. E

    Case mx200 transmission fault.

    Hi Richard thanks very much for your reply, apologies I've been busy over Christmas. Yes it's an mx200 magnum, would you reccomend having a look at that gear pump? There is no low pressure lights on but I'm not sure if the lights are working. Cheers
  6. E

    Case mx200 transmission fault.

    They have a driveshaft mate it's all good
  7. E

    Case mx200 transmission fault.

    Hi Richard thanks very much for your reply, apologies I've been busy over Christmas. Yes it's an mx200 magnum, would you reccomend having a look at that gear pump? There is no low pressure lights on but I'm not sure if the lights are working. Cheers
  8. E

    Case mx200 transmission fault.

    ah grand, do you mean the charge pump inside the piston pump or is there another in the gearbox? excuse the aquestions
  9. E

    JCB 535-60 JUMPING OUT OF 3RD GEAR

    Hi all, we have a JCB 536-60, when travelling on the road every 10 seconds or so just jumps back down to 2nd gear from 3rd, does it regardless of weather or not it is in auto. any help would be very much appreciated.
  10. E

    Case mx200 transmission fault.

    Thanks for that, would that cause intermittent drive? Cheers
  11. E

    Case mx200 transmission fault.

    Dont think so mate, pto not spinning either. Will have to out my gauge into the spools but it didnt sound like they were working.
  12. E

    Case mx200 transmission fault.

    Hi all, we have a case mx200, it has no steering and wont drive at all. It occasionally takes up drive for 3 or 4 feet then jumps back out. No low pressure lights on dash or anything.
  13. E

    manitou mt 625 not driving

    brilliant thanks, will have a look at this tommorow. yes i havent seen the plu6 d thing before either, hopefully i can get some codes. much appreciated.
  14. E

    manitou mt 625 not driving

    hi all, i have an issue with my manitou 625, it will not go forwards or reverse, hydraulics will not move unless the parachute button is pressed and the rev counter is not working. the alternator is charging good at 14.6 volts (could this be too much) all wiring checked so far looks ok, the...
Top