Search results

I’ve made a couple of metal ones not as easy as you think. They both turns out different to what I was thinking of at the start . the angles will give you a headache and the 4 pieces need to be bigger than you think.

I did that I’ll wait abit on farm shed must of cost double of what it would have done. 2 yrs ago Just getting to the roof now. 😆

Silly question . Big yes. Get busy.

+1 great job could only hope for more of the same round hear.

It would take many yrs to get them back to near how they should be I think that’s the problem as a government is in for such a short time they wouldn’t get the Recognition for spending on it. They Are just hoping they do t get a big flood in there short time. We get some land 1/4 flooding from...

There’s no hope . the government should be ashamed of the state of the water Ways. It’s just going to make it worse if there prosecuting for what is essentially back dated maintenance.

4 buckets… and eyes 2 behind the tractor in the tramline 2 in the middle between the tramlines. Look see if there the same or measure with small test tube or 5mm syringe tube. Easiest way to check And none time consuming. Any liquid tank fill prices yet ?

Up date on the turbo actuator John Deere fitted all done. Linkage on the turbo was free so went with actuator only.

My linseeds done

Found something funny

Yes I did get 1 error code followed by the 50% reduction in power. Yes rattle noises from the actuator it’s definitely done.

Claas arion 650Turbo actuator 3100hrs gets a thumbs 👎any heads up on where to get a replacement.

I can change the pluses from the lazer control I’ll try that first.. and there are some looks like restriction valves in the Hyd hose line well guess that’s what they are but the solenoid valve is just open / closed.

The best looking plots were from a vertical disc and vertical tine . Go figure . Which post was slagging wardy ( barstools) Name and shame

V Dry here that graph is Optimistic.

Lazer grade controls Trimble CB60 all working but it’s jumpy when operating the system is plumed into the 2 front Hyd rams with the rear Hyd ram in float as it should be. But y is it so jumpy. Any one running a plow in lazer control guess it should be smooth. Should I change it over to the rear...

spring drilling went very here but no rain still going to fudge it up

I’ve tried the 2.5 inch points with the front cutting disc into cover .I’ve used the Spaldings 7 inch I liked them got a good spread of seed and I’m going to try the 5inch ones next autumn. I’ve also drilled some spring barley on the 1inch point. think the lack of rain is the problem. Not the...

Looked like the Moore drill was the best by some way from the video. Followed by the Amazone. What’s wardy done ! quad tracks gone.

Had the starter motor go on the 400. By passed the starter relay nothing .. diagnosed starter. fixed could it be that.