Search results

Ransomes 51 Marquis cylinder mower for sale. Used to use it to keep the lawn looking incredibly tidy and short. Has a new fuel tank, runs well. Still for sale.

Very impressive bit of kit, can you get them in the UK?

Ransomes 51 Marquis cylinder mower for sale. Used to use it to keep the lawn looking incredibly tidy and short. Has a new fuel tank, runs well. Started this morning in a couple of pulls after being fuelled. Not been started for a while but mowed ok. £150 buyer collects, its large and heavy!

Hello, what condition is yours in? Do you know it's age? Is it a red or a green one? Thanks

Sold

True we could refit the drum back and weld it in place. Ironically it was the good drum that parted company with the mower. The bottom disc on the other drum is not spinning freely. Hits something internally. Looked at trying to take it off to investigate but studs holding it on are too tight...

Good afternoon, After many years of service my rather old KM22 parted with a drum yesterday morning. Is there any value in any of it for parts or is it all heading straight to the scrap man? I have decided that repairing it probably isn't going to be cost effective, as it had a fault before...

Secondhand John Deere JS63 mulching mower. In good condition, starts first pull of the cord. No longer used as we now collect the grass clippings, so I have decided to sell it. Has a homemade fix on the self propelled cable, these seem to be the weak point of the machine. £150 Thank you

I assume that is a 4wd vineyard tractor, has it been tried behind a 2wd standard tractor (80hp)?

What horsepower requirement is needed to pull the two leg version?

Thank you, I was asking as we have a Ransomes mole plough/subsoiler. May be worth an experiment on some tough areas of pasture. We have had water standing on higher ground suggesting the soil could be compacted and not letting it drain away. Sorry grandpapete completely highjacked your thread!

I assume this was mean't to be humorous, would you get any shatter from a mole plough?

What have you been buying?? :unsure:

We have an old slurry tanker with a spare 6" opening blanked off. We are think of using it as a large mobile water tanker for watering a nursery. Looking at this NC tanker there is a smaller fitting to the right at the rear. What is this called? Who sells them? Struggling to find such a...

Ask to see the scrap/off cut bins just inside the door, two sections of box 1140mm long the other day £4. Great for what I needed. The metal in the bins does change from week to week. Previous purchase 100mm x 100mm angle again just over a metre long, cut what I needed and have a spare piece...

Ok, looks like I'll need a magnifying glass!

I've have the side under the rev counter out and soldered up a lose capacitor but I doubt that is the cause. What do cracked joints look like? It all looked OK to me, but I'm not too sure what I'm looking for.

Hi, With the hazard warning switch in place, the flasher unit is constantly ticking, but the indicators don't flash. I can replicate by removing the hazard warning switch and putting a piece of wire across 15 to 45. This is technically off, but allows the circuit to operate i.e. lets you use...

Used to stall really easily if I remember correctly, needed revs to make it move

I'm not sure that's right Stihl have an aspen equivalent which they sell through their dealers